Link-Watts, Upper

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Before proceeding, see WARNING .

Raise and support the vehicle. Refer to STANDARD PROCEDURE .

Fig 1: Exploded View Of Watts Linkage System
Courtesy of CHRYSLER LLC
Remove the cap (6) from the ball joint nut (5).
Remove the nut (5) securing the link ball joint to the bell crank (9).
Install Remover, Special Tool MB991113, on the link (3) ball joint at the bell crank and release the ball joint from the bell crank.

Fig 2: Watts Link To Body Attaching Points
Courtesy of CHRYSLER LLC
Remove the bolt (1) and nut (2) securing the link (3) to the body bracket (7). See Figure.
Remove the upper link (3).