Stabilizer Bar Link
WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - LINK |
| 2 - STABILIZER BAR |
| 3 - CUSHION |
| 4 - RETAINER |
NOTE:
Stabilizer bar link fasteners need to be tightened to specifications when the vehicle is at curb height.
- Install the stabilizer bar link (1), starting the bolt retaining the link to the frame rail. Do not tighten the bolt at this time.
- Install the lower bolt and nut attaching the stabilizer bar link (1) to the stabilizer bar (2). Do not tighten the bolt and nut at this time.
- Install the tire and wheel assembly (1). Refer to INSTALLATION . Install and tighten wheel mounting nuts (3) to 135 N.m (100 ft. lbs.).
- Lower the vehicle.
- Tighten the stabilizer bar link upper bolt and lower bolt to 65 N.m (48 ft. lbs.).