LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Suspension System) >> Rear Suspension >> Hub/Bearing >> Removal >> Hub And Bearing - Rear Disc Brake Vehicles

Hub And Bearing - Rear Disc Brake Vehicles

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Before proceeding, see WARNING .
  1. Raise and support the vehicle. Refer to STANDARD PROCEDURE .
    Fig 1: Tire & Wheel Mounting Method
    GC0041085Courtesy of CHRYSLER LLC
  2. Remove the wheel mounting nuts (3), then the rear tire and wheel assembly.
    Fig 2: Rear Disc Brakes, Hub And Spindle Components
    GC0041084Courtesy of CHRYSLER LLC
  3. Remove the disc brake caliper guide pin bolts (4), then the caliper (1) from the disc brake adapter (3).
  4. Hang the caliper (1) out of the way using a wire hanger or bungee cord. Do not allow the caliper to hang by the flex hose; damage to the hose may occur. 
  5. Remove the brake rotor retaining clips (9), then the brake rotor (8).
  6. Remove the dust cap (10) from the hub and bearing (2).
  7. Remove the hub nut (11), then slide the hub and bearing (2) from the spindle (6).
scientia non olet · About LEMON Manuals