Hub And Bearing - Rear Drum Brake Vehicles
WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Slide the hub and bearing (7) onto the spindle (10).
- Install a NEW hub nut (3) on the spindle. Tighten the nut to 217 N.m (160 ft. lbs.).
- Install the hub and bearing dust cap (4).
- Adjust the rear brakes as necessary. Refer to ADJUSTMENTS .
- Install the brake drum (6).
- Install tire and wheel assembly (1). Refer to INSTALLATION . Install and tighten wheel mounting nuts (3) to 135 N.m (100 ft. lbs.).
- Lower the vehicle.