LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Suspension System) >> Rear Suspension >> Hub/Bearing >> Installation >> Hub And Bearing - Rear Disc Brake Vehicles

Hub And Bearing - Rear Disc Brake Vehicles

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Disc Brakes, Hub And Spindle Components
GC0041084Courtesy of CHRYSLER LLC
  1. Slide the hub and bearing (2) onto the spindle (6).
  2. Install a NEW hub nut (11) on the spindle. Tighten the nut to 217 N.m (160 ft. lbs.).
  3. Install the hub and bearing dust cap (10).
  4. Install the brake rotor (8) and caliper (1). Install and tighten the caliper guide pin bolts (4) to 22 N.m (192 in. lbs.). Refer to INSTALLATION .
  5. Install the bolt securing the disc brake flex hose to the axle.
    Fig 2: Tire & Wheel Mounting Method
    GC0041085Courtesy of CHRYSLER LLC
  6. Install tire and wheel assembly (1). Refer to INSTALLATION . Install and tighten wheel mounting nuts (3) to 135 N.m (100 ft. lbs.).
  7. Lower the vehicle.
  8. Pump the brake pedal several times to ensure the vehicle has a firm brake pedal before moving the vehicle.
scientia non olet · About LEMON Manuals