LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Restraints System (Service Information)) >> Restraints >> Retractor-Front Seat Belt - Pt27 >> Removal >> Retractor-Front Seat Belt - Pt27

Retractor-Front Seat Belt - Pt27

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Seat Belt Web Guide
GC0023005Courtesy of CHRYSLER LLC
WARNING: If equipped with Seat Belt Tensioners, the retractor will have pyrotechnics inside the retractor assembly and must be handled with care. See WARNING .
  1. Disconnect and isolate the battery negative cable.
    WARNING: Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components. Failure to do this may result in serious or fatal injury.
  2. Remove the seat belt from within the seat belt web guide.
    Fig 2: Replacing Front Seat Belt
    GC0053716Courtesy of CHRYSLER LLC
  3. Slide seat to the full forward position.
  4. Using a trim stick or equivalent, gently pry off the seat belt anchor bolt cover (1) on the outboard side of the seat cushion side panel.
  5. Remove the seat belt anchor bolt (2).
    Fig 3: Removing/Installing Retractor
    GC0023003Courtesy of CHRYSLER LLC
  6. Remove the upper turning loop retaining bolt (1).
    Fig 4: Identifying Tensioner Squib Connector
    GC0023004Courtesy of CHRYSLER LLC
  7. Remove the Lower Quarter Trim Panel. Refer to REMOVAL .
  8. Disconnect the tensioner squib connector (1).
    Fig 5: Removing/Installing Retractor
    GC0023003Courtesy of CHRYSLER LLC
  9. Remove the one bolt to the front seat belt retractor (3).
  10. Remove retractor from vehicle.
scientia non olet · About LEMON Manuals