Cover-Driver Airbag

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Securing Driver Airbag Cover Latch Hooks

Courtesy of CHRYSLER LLC

Place driver airbag into new driver airbag cover.
WARNING: Be careful not to pinch airbag cushion between latch hook mounting plate and cover.
Push down on the latch hook mounting plate and guide the latch hooks into the slots on the driver airbag cover.
Once all the latch hooks have been started, pull the driver airbag cover away from the driver airbag to fully seat the latch hooks.
Install the driver airbag. See INSTALLATION .

WARNING: Do not connect the battery negative cable. See DIAGNOSIS AND TESTING . Serious or fatal injury may result if the system test is not performed first.