LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Vehicle Theft Security System - Electrical Diagnostics) >> Vehicle Theft Security - Electrical Diagnostics >> DTC Troubleshooting >> B222A-Vehicle Line Mismatch >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. 1) CONFIGURE THE INTRUSION TRANSCEIVER MODULE 

    Using the scan tool under miscellaneous functions perform the initialization procedure for the Intrusion Transceiver Module.

    With the scan tool, clear DTC(s).

    Turn the ignition off and remove the key from the ignition.

    Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute.

    Disarm the VTSS.

    Using the scan tool, read DTC(s).

    Does the DTC reset? 

    Yes 

    1. Replace the Intrusion Transceiver Module in accordance with the Service Information.
    2. Perform BODY VERIFICATION TEST - VER 1 .

    No 

    1. Test complete.
    2. Perform BODY VERIFICATION TEST - VER 1 .
scientia non olet · About LEMON Manuals