Rear Seat

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Seat

Courtesy of CHRYSLER LLC

1 - REAR SEAT

Fold seat back down and then roll forward to access disengage hooks.

Fig 2: Rear Seat Latch & Cover
Courtesy of CHRYSLER LLC
Remove rear seat latch cover before seat removal.
Disengage hooks and remove rear seat (1) from vehicle.

Fig 1: Check Strap

Courtesy of CHRYSLER LLC

1 - CHECK STRAP

2 - ATTACHING SCREW

Fold rear seats forward and remove screw (2) attaching check strap (1) on each side of vehicle.
Remove latch covers. See REMOVAL .

Fig 2: PT-27 Seat Latch & Latching Device
Courtesy of CHRYSLER LLC

1 - LATCHING DEVISE
Fold seat back down and then roll forward to access rear seat latch latching devices (1).

Fig 3: PT-27 Seat Latch
Courtesy of CHRYSLER LLC

1 - ROD
To disengage latching devise, rock latching devise rearward and install a rod (1) into the hole to support latching devise in the open position.

Fig 4: Rear Seat Latches
Courtesy of CHRYSLER LLC

1 - LATCH(ES)

With both latches (1) in the open position the seat may be removed.

Fig 5: Pivot Bracket(s)

Courtesy of CHRYSLER LLC

1 - REAR FLOOR PAN

2 - REAR SEAT LATCH(ES)

3 - ATTACHING BOLTS

Remove latches (2), if necessary. Remove attaching bolts (3) and remove latch (2).