Quarter Glass - Convertible
WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- If required, position the quarter glass (1) and bushings (6) onto the quarter window module (3) and loosely install the three screws (5) and nuts (2) that secure quarter glass to the window module.
- Install the quarter window module into position through the opening in the top of the quarter panel.
- Install the three nuts (4) that secure the quarter window module to inner quarter panel. Tighten the nuts securely.
- Connect the wire connector to the power window motor.
- Raise the convertible top.
- Adjust quarter glass as necessary and tighten the three screws and nuts that secure quarter glass to the window module. See ADJUSTMENTS .
- Install the water dam onto the inner quarter panel. Make sure that enough adhesive remains to securely retain the water dam. Replace the water dam if required.
- Install the rear quarter trim panel. See INSTALLATION .