Relay-Power Top - Convertible
WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Start with the folding top in the raised and latched position.
- Disconnect and isolate the battery negative cable.
- Remove the rear seat back, refer to REMOVAL .
- Remove the well liner/carpet from the power top well.
- Remove the foam pump cover from over the motor/hydraulic pump.
- Disconnect the motor/hydraulic pump relay wire harness connector (3).
- Depress the relay retaining tab and remove the relay (2) from the bracket.