Relay-Power Top - Convertible
WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Position the motor/hydraulic pump relay (2) onto the relay bracket and push into place so that the retaining tab is fully seated.
- Connect the motor/hydraulic pump relay wire harness connector (3).
- Install the foam pump cover.
- Install the well liner/carpet into the power top well.
- Install the rear seat back, refer to INSTALLATION .
- Connect the battery negative cable.
- Verify normal power top system operation.