Diagnostic Test

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

1) CHECK FOR AN ACTIVE DTC
Turn the ignition on.

With the scan tool, record and erase DTCs.

Wait 30 seconds.

With the scan tool, read DTCs.

Does the scan tool display: U113B-LOST COMMUNICATION WITH SWITCH BANK MODULE?

Yes
1. Go to 2).
No
1. The condition that caused this code to set is not present at this time. Check for an intermittent condition by inspecting the related wiring harness for chaffed, pierced, pinched and partially broken wires. Also inspect the related connectors for broken, bent, pushed out, spread, corroded or contaminated terminals.
2. Perform BODY VERIFICATION TEST - VER 1 .
2) (D506) LIN BUS CIRCUIT OPEN

Fig 1: Measuring Voltage Of LIN BUS Circuit
Courtesy of CHRYSLER LLC

Turn the ignition off.

Disconnect the Switch Bank harness connector.

Turn the ignition on.

Measure the voltage of the (D506) LIN BUS circuit.

Is the voltage above 5 volts?

Yes
1. Go to 3).
No
1. Repair the (D506) LIN BUS circuit for an open.
2. Perform BODY VERIFICATION TEST - VER 1 .
3) (A935) FUSED B+ CIRCUIT OPEN

Fig 2: Measuring Voltage Of Fused B+ Circuit
Courtesy of CHRYSLER LLC

Measure the voltage of the (A935) Fused B+ circuit.

Is the voltage above 10 volts?

Yes
1. Go to 4).
No
1. Repair the (A935) Fused B+ circuit for an open.
2. Perform BODY VERIFICATION TEST - VER 1 .
4) (Z908) GROUND CIRCUIT OPEN

Fig 3: Measuring Resistance Between Ground & Ground Circuit
Courtesy of CHRYSLER LLC

Measure the resistance between ground and the (Z908) Ground circuit.

Is the resistance below 10K ohms?

Yes
1. Replace the Switch Bank in accordance with the service information.
2. Perform BODY VERIFICATION TEST - VER 1 .
No
1. Repair the (Z908) ground circuit for an open.
2. Perform BODY VERIFICATION TEST - VER 1 .