LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Engine & Automatic Transmission Cooling System) >> Accessory Drive >> Pulley-Idler >> Installation >> Installation

Accessory Drive: Pulley-Idler: Installation: Installation

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Idler Pulley
GC0021789Courtesy of CHRYSLER LLC
1 - IDLER PULLEY FASTENER
2 - IDLER PULLEY
  1. Position pulley (2) in mounting position. Install fastener securing idler pulley (1) to front of engine. Torque fastener to 28 N.m (250 in. lbs.).
  2. Install accessory drive belt. See INSTALLATION .
  3. Install belt splash shield.
  4. Lower vehicle.
  5. Connect negative battery cable.
scientia non olet · About LEMON Manuals