LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> 2.4L Engine - DTCS PO509 To P0850 >> Diagnosis And Testing >> P0632-Odometer Not Programmed In Pcm >> Diagnostic Test

Diagnostic Test

  1. 1)  PROGRAMMING MILEAGE INTO THE PCM 

    Ignition on, engine not running.

    With the scan tool, erase DTCs.

    Using a scan tool, program the mileage into the PCM.

    Start the engine.

    Allow the engine to reach normal operating temperature.

    With a scan tool, read DTCs.

    Does the DTC reset? 

    Yes 

    1. Replace and program the Powertrain Control Module per Service Information. Refer to MODULE-POWERTRAIN CONTROL and STANDARD PROCEDURE - PCM/ECM/SKREEM PROGRAMMING .
    2. Perform the POWERTRAIN VERIFICATION TEST. (Refer to STANDARD PROCEDURE - POWERTRAIN VERIFICATION TEST)

    No 

    1. The mileage has been successfully programmed into the PCM. Test is complete.
    2. Perform the POWERTRAIN VERIFICATION TEST. (Refer to STANDARD PROCEDURE - POWERTRAIN VERIFICATION TEST) .
scientia non olet · About LEMON Manuals