LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> 1.6L Engine - DTCS P2138 To U0168 & Verification Tests >> Standard Procedure >> Gateway Verification Test - VER 1 >> Diagnostic Test

Diagnostic Test

  1. 1)  Perform Gateway Verification Test 

    1. Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
      NOTE: If the SKREEM or PCM was replaced, refer to the service information for proper programming procedures.(Refer to STANDARD PROCEDURE - PCM/ECM/SKREEM PROGRAMMING) .
    2. Ensure that all accessories are turned off.
    3. Ensure that the battery is fully charged.
    4. Turn the ignition on.
    5. With the scan tool, record and erase DTCs from all modules.
    6. If an electronic control module was replaced, select the applicable module from the scan tool menu and press "Misc. Functions". If the module has programmable features, program as necessary.
    7. Turn the ignition off, wait 10 seconds, and then turn the ignition on.
    8. Operate all functions of the system that caused the original concern.
    9. With the scan tool, select ECU View and check for DTCs in the modules.

    Are DTCs present in any of the modules or is the original condition still present? 

    Yes 

    1. The repair is not complete. Refer to the related category for the DTC or symptom that is still present.

    No 

    1. The repair is complete.
scientia non olet · About LEMON Manuals