2.4L DOHC Engine: Arms-Rocker: Removal

Fig 1: Rocker Arm - Removal/Installation

Courtesy of DAIMLERCHRYSLER CORP.

1 - VALVE SPRING COMPRESSOR 8215A

2 - ADAPTER 8436

3 - 3/8" DRIVE RATCHET

NOTE: This procedure is for in-vehicle service with camshafts installed.

1. Remove cylinder head cover (Refer to ENGINE/CYLINDER HEAD/CYLINDER HEAD COVER(S) - REMOVAL) .
2. Remove spark plugs.
3. Rotate engine until the camshaft lobe, on the follower being removed, is positioned on its base circle (heel). Also, the piston should be a minimum of 6.3 mm (0.25 in) below TDC position.
   CAUTION: If cam follower assemblies are to be reused, always mark position for reassembly in their original positions.
4. Using Valve Spring Compressor 8215A (1) and Adapter 8436 (2) slowly depress valve assembly until rocker arm can be removed. See Fig 1.
5. Repeat removal procedure for each rocker arm.