Cylinder Bore And Piston - Fitting

Fig 1: Piston Measurement Location

Courtesy of DAIMLERCHRYSLER CORP.

1 - PISTON DIAMETER

2 - 14 mm (9/16 in.)

Piston and cylinder wall must be clean and dry. Piston diameter should be measured 90 degrees to piston pin (1) about 14 mm (9/16 inch.) from the bottom of the skirt (2) as shown. See Fig 1.

Fig 2: Checking Cylinder Bore Size

Courtesy of DAIMLERCHRYSLER CORP.

Cylinder bores should be measured halfway down the cylinder bore and transverse (measurement location B) to the engine crankshaft center line. See Fig 2. (Refer to ENGINE - SPECIFICATIONS) Correct piston to bore clearance must be established in order to assure quiet and economical operation.

NOTE: Pistons and cylinder bores should be measured at normal room temperature, 70°F (21°C).