Coolant Supply Line

Fig 1: Banjo Bolt and Washers

Courtesy of DAIMLERCHRYSLER CORP.

1 - BANJO BOLT

2 - WASHERS

If brass fitting was removed from engine block, apply thread sealer to threads and install in engine block. Torque brass fitting to 41 N.m (30 ft. lbs.).
Position coolant supply line to mounting location.
Install NEW washers (2) on banjo fitting of coolant supply line. Hand start banjo bolt. See Fig 1.
Hand start flared fitting of coolant supply line.
Torque banjo fitting bolt to 37 N.m (27 ft. lbs.).
Torque flared fitting to 31 N.m (23 ft. lbs.).
Lower vehicle.
Fill cooling system, (Refer to COOLING/ENGINE/COOLANT - STANDARD PROCEDURE) .