Wiring Diagram Information: Connector: Removal

Fig 1: Removing Dress Cover

Courtesy of DAIMLERCHRYSLER CORP.

1 - DRESS COVER

2 - CONNECTOR LOCK

3 - CONNECTOR

1. Disconnect battery.
2. Release Connector Lock (2).
3. Disconnect the connector (3) being repaired from its mating half/component.
4. Remove the dress cover (if applicable) (1).
   Fig 2: Examples of Connector Secondary Terminal Locks

   Courtesy of DAIMLERCHRYSLER CORP.

   1 - Secondary Terminal Lock

5. Release the Secondary Terminal Lock, if required (1).
   Fig 3: Removing Terminal

   Courtesy of DAIMLERCHRYSLER CORP.

   1 - TYPICAL CONNECTOR

   2 - PICK FROM SPECIAL TOOL KIT 6680

   3 - APEX CONNECTOR

   4 - PICK FROM SPECIAL TOOL KIT 6680

   5 - AUGAT CONNECTOR

   6 - SPECIAL TOOL 6932

   7 - MOLEX CONNECTOR

   8 - SPECIAL TOOL 6742

   9 - THOMAS AND BETTS CONNECTOR

   10 - SPECIAL TOOL 6934

   11 - TYCO CONNECTOR

   12 - SPECIAL TOOL 8638

6. Position the connector locking finger away from the terminal using the proper special tool. Pull on the wire to remove the terminal from the connector.