Installation - Convertible
Courtesy of DAIMLERCHRYSLER CORP.
- If required, position the quarter glass (1) and bushings (6) onto the quarter window module (3) and loosely install the three screws (5) and nuts (2) that secure quarter glass to the window module.
- Install the quarter window module into position through the opening in the top of the quarter panel.
- Install the three nuts (4) that secure the quarter window module to inner quarter panel. Tighten the nuts securely.
- Connect the wire connector to the power window motor.
- Raise the convertible top.
- Adjust quarter glass as necessary and tighten the three screws and nuts that secure quarter glass to the window module (Refer to BODY/DOOR - FRONT/DOOR GLASS-CONVERTIBLE - ADJUSTMENTS)
.
- Install the water dam onto the inner quarter panel. Make sure that enough adhesive remains to securely retain the water dam. Replace the water dam if required.
- Install the rear quarter trim panel (Refer to BODY/INTERIOR/TRIM-QUARTER PANEL - INSTALLATION) .