Removal - Convertible

Fig 1: Header Center Molding

Courtesy of DAIMLERCHRYSLER CORP.

Remove the sun visor and sun visor retainer (Refer to BODY/INTERIOR/VISOR-SUN - REMOVAL) .
Using a trim stick C-4755 or equivalent, release the snap retainers that secure the header center molding (2) to the inside of the windshield surround frame (1).

Fig 2: HEADER END MOLDINGS
Courtesy of DAIMLERCHRYSLER CORP.
Using a trim stick C-4755 or equivalent, release the three snap retainers (1) that secure each header end molding (2) to the inside of the windshield surround frame (3).
Remove each header end molding from the windshield surround frame and if equipped, route the sun visor wire harness connector (4) through the molding.