Assembly-Wire Harness: Installation

Fig 1: Convertible Top Wire Harness

Courtesy of DAIMLERCHRYSLER CORP.

Position the convertible top wire harness into the vehicle.
Connect the convertible top wire harness connector (2) to the body wire harness connector (3).
Route the rear window defogger wire lead (1) through the wire slings and connect the wire connectors to the rear window defogger terminals.

Fig 2: Motor/Hydraulic Pump Assembly
Courtesy of DAIMLERCHRYSLER CORP.
Connect the convertible top wire harness (3) to the pump motor (1).
Install the three retaining clips that secure the convertible top wire harness and relay (2) to the body.

Fig 3: Hydraulic Pump Protective Cover
Courtesy of DAIMLERCHRYSLER CORP.
Install the protective cover (3) to the top of the hydraulic pump/motor assembly (4) located on the shelf panel.

Fig 4: Convertible Top Well
Courtesy of DAIMLERCHRYSLER CORP.
Position the convertible top well liner (2) into the vehicle and install the push-pins (1) that secure the liner to the rear seat back panel (3) and body (4).
Install the rear seat back (Refer to BODY/SEATS/SEAT BACK-REAR - INSTALLATION) .
Install the left interior quarter trim panel (Refer to BODY/INTERIOR/TRIM-REAR QUARTER PANEL - INSTALLATION) .
Install the rear seat cushion (Refer to BODY/SEATS/CUSHION-REAR - INSTALLATION) .