LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Body & Frame >> Frames, Subframes & Crossmembers >> Frames & Bumpers >> Front Bumper Fascia >> Removal

Front Bumper Fascia: Removal

Fig 1: Front Bumper Fascia
GC0021971Courtesy of DAIMLERCHRYSLER CORP.
  1. Remove grille. (Refer to BODY/EXTERIOR/GRILLE - REMOVAL) .
  2. Remove three screws attaching splash shield to fascia to access fender flange on each side of vehicle.
  3. Remove spring nuts fasteners attaching fascia to fender flange.
  4. Raise and support vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE) .
  5. Remove three screws attaching air dam (3) and lower fascia to the radiator support crossmember.
  6. Lower vehicle.
    Fig 2: Fascia Attaching Points
    GC0021972Courtesy of DAIMLERCHRYSLER CORP.
  7. Remove two fasteners attaching fascia (2) to the fender bracket.
  8. Remove fascia to access the fog lamp wire connectors and disconnect, if equipped.
    Fig 3: Front Fascia - Lower Grille Chrome A
    GC0021973Courtesy of DAIMLERCHRYSLER CORP.
    1 - FRONT FASCIA
    2 - SPRING NUTS (6)
    3 - PUSH PIN FASTENER
    4 - LOWER RADIATOR GRILLE
    5 - CHROME STRIPS
  9. Remove fascia (1) from vehicle.
  10. Move fascia to a bench.
  11. Remove the air dam, retaining fasteners, foam, and fog lamps if equipped. (Refer to BODY/EXTERIOR/GRILLE - LOWER RADIATOR REMOVAL) .
  12. Remove lower radiator grille (4), if equipped.
scientia non olet · About LEMON Manuals