LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Vehicle Theft Security System - Electrical Diagnostics >> Vehicle Theft Security - Electrical Diagnostics >> DTC Troubleshooting >> B1A48-Intrusion Sensor 1 Internal >> Diagnostic Test

Diagnostic Test

  1. 1)  INTERMITTENT DTC 

    With the scan tool, erase the current Intrusion Transceiver Module DTC's.

    Turn the ignition off.

    Arm the VTSS and wait 1 minute.

    Disarm the VTSS and turn the ignition on.

    Does the scan tool display the same DTC? 

    Yes 

    1. Replace the Intrusion Sensor in accordance with the Service Information (Refer to INTRUSION SENSOR - EXPORT) .
    2. Perform BODY VERIFICATION TEST - VER 1. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE - BODY VERIFICATION TEST - VER 1) , also see (STANDARD PROCEDURE - PCM/ECM/SKREEM PROGRAMMING) .

    No 

    1. The condition that caused this symptom is currently not present. Inspect the related wiring harness for a possible intermittent condition. Look for any chafed, pierced, pinched or partially broken wires.
    2. Perform BODY VERIFICATION TEST - VER 1. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE - BODY VERIFICATION TEST - VER 1) , also see (STANDARD PROCEDURE - PCM/ECM/SKREEM PROGRAMMING) .
scientia non olet · About LEMON Manuals