Right Multi-Function Switch: Installation

Fig 1: Right Multi-Function Switch Harness Connector

Courtesy of DAIMLERCHRYSLER CORP.

1. Position the right multi-function switch to the back of the Steering Column Control Module (SCCM) (3) and connect the switch connector (1).
   Fig 2: Right Multi-Function Switch Retaining Screw

   Courtesy of DAIMLERCHRYSLER CORP.
2. Align switch with the SCCM (2) and slide toward steering column.
3. Install the screw (3) that secures the switch (2) to the SCCM (1).
4. Install the upper and lower shrouds onto the steering column. (Refer to SHROUD-UPPER and SHROUD-LOWER .
5. Connect the battery negative cable.