LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting Systems - Exterior (Service Information) >> Multi-Function Switch >> Removal

Multi-Function Switch: Removal

NOTE: It is not necessary to remove the Steering Column Control Module (SCCM) from the steering column to replace the left multi-function switch.
  1. Disconnect and isolate the battery negative cable.
    2. WARNING: Wait two minutes for the system reserve capacitor to discharge before servicing any airbag or steering column components.
  2. Remove both the upper and lower shrouds from the steering column.
  3. Remove the one screw (2) that secures the left multi-function switch (3) on the right side of the SCCM (1).
  4. Pull the switch (2) straight away from the SCCM (1) far enough to access the electrical connector (3) to disconnect it from the SCCM
    Fig 1: Multi-Function Switch Removal/Installation
    G00229351Courtesy of DAIMLERCHRYSLER CORP.
  5. Disconnect the instrument panel wiring harness from the back of the left multi-function switch.
  6. Remove the switch (2) from the SCCM (1).
    Fig 2: Removing/Installing Switch At SCCM
    G00229352Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals