LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting Systems - Exterior (Service Information) >> Brake Lamp Switch >> Removal

Brake Lamp Switch: Removal

  1. Unclip the air cleaner cover (two clips) and move the cover aside.
  2. Disconnect and isolate the battery negative cable from its post on the battery.
  3. Remove the silencer pad below the knee blocker.
  4. Fold down and remove the knee blocker below the steering column.
  5. Remove the brake lamp switch from its bracket by rotating the switch in a counterclockwise direction approximately 30 degrees, then pulling the switch rearward.
  6. Disconnect the wiring harness connector.
  7. Discard the brake lamp switch. It must not be reused. 
scientia non olet · About LEMON Manuals