Cruise Control Systems: Servo: Installation: 1.6/2.0L

Fig 1: Cable Retaining Clip

Courtesy of DAIMLERCHRYSLER CORP.

1 - HAIRPIN CLIP

1. Install hairpin clip to servo and cable. See Figure.
   Fig 2: Throttle Cable Attachment To Throttle Body

   Courtesy of DAIMLERCHRYSLER CORP.
2. Install servo studs through cable bell and then the bracket.
3. Install nuts, tighten to 7 N.m (60 in. lbs.).
4. Install speed control cable to throttle cam. Refer to cable INSTALLATION .
   Fig 3: Vacuum And Electrical Connection At Servo

   Courtesy of DAIMLERCHRYSLER CORP.

   1 - Electrical Connector

   2 - Vacuum Line and Nipple

5. Connect electrical connector.
6. Connect the vacuum hose to servo.
7. Install the engine cover.
   Fig 4: Removing/Installing Battery Negative Cable

   Courtesy of DAIMLERCHRYSLER CORP.
8. Install the negative battery cable.
9. Install the air cleaner lid, and makeup air hose.