LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Cable >> Removal >> 2.4L Turbo

2.4L Turbo

Fig 1: Throttle Control Shield
GC0021943Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect the negative battery cable.
  2. Remove the throttle control shield. See Fig 1.
    Fig 2: Locating Retaining Tabs On Cables
    GC0021665Courtesy of DAIMLERCHRYSLER CORP.
  3. Remove the speed control cable from the throttle body lever.
  4. Remove from throttle cable bracket by compressing the retaining tabs on the cable and slide cable out of the bracket. See Fig 2.
    Fig 3: Vacuum And Electrical Connection At Servo
    GC0021946Courtesy of DAIMLERCHRYSLER CORP.
    1 - Electrical Connector
    2 - Vacuum Line and Nipple
  5. Remove the vacuum line from the speed control servo.
    Fig 4: Speed Control Servo - 2.4L Turbo
    GC0021945Courtesy of DAIMLERCHRYSLER CORP.
  6. Remove the 2 nuts from the speed control servo studs. See Fig 4.
    Fig 5: Cable Retaining Clip
    GC0021942Courtesy of DAIMLERCHRYSLER CORP.
    1 - HAIRPIN CLIP
  7. Push and pull up the speed control servo from the mounting bracket.
  8. Unlock and disconnect the electrical connector from the speed control servo. See Fig 3.
  9. Remove the 2 push clips and discard.
  10. Remove the retaining clip holding cable to servo. See Fig 5.
  11. Remove the cable.
scientia non olet · About LEMON Manuals