Cruise Control Systems: Cable: Removal: 1.6/2.0L

Fig 1: Speed Control System Components

Courtesy of DAIMLERCHRYSLER CORP.

1. Remove the air cleaner and makeup air hose. Refer to appropriate article. Refer to (Refer to ENGINE/AIR INTAKE SYSTEM/AIR CLEANER ELEMENT - REMOVAL) or (Refer to ENGINE/AIR INTAKE SYSTEM/AIR CLEANER ELEMENT - REMOVAL) .
2. Remove the negative battery cable.
3. Remove the engine cover and throttle control shield, if equipped.
4. Remove two nuts attaching speed control cable and mounting bracket to servo. See Fig 1.
5. Remove servo from the mounting bracket.
6. Disconnect electrical connector and vacuum hose.
   Fig 2: Cable Retaining Clip

   Courtesy of DAIMLERCHRYSLER CORP.

   1 - HAIRPIN CLIP

7. Remove retaining clip holding cable to servo.
   Fig 3: Throttle Cable Attachment To Throttle Body

   Courtesy of DAIMLERCHRYSLER CORP.
8. Remove throttle cable clasp from the throttle body cam. See Fig 3.
9. Remove speed control cable from throttle cam by sliding clasp out hole used for throttle cable.
   Fig 4: Locating Retaining Tabs On Cables

   Courtesy of DAIMLERCHRYSLER CORP.
10. Compress the retaining tabs on the cables and slide cables out of bracket. See Fig 4.