Cruise Control Systems: Cable: Installation: 1.6/2.0L

Fig 1: Cable Retaining Clip

Courtesy of DAIMLERCHRYSLER CORP.

1 - HAIRPIN CLIP

1. Install cable core wire through center hole on bracket, onto servo center post.
2. Install retaining clip to cable at servo. See Figure.
   Fig 2: Locating Retaining Tabs On Cables

   Courtesy of DAIMLERCHRYSLER CORP.
3. Slide cable bell housing over servo mounting studs through the bracket.
4. Install 2 nuts, tighten to 7 N.m (60 in. lbs.).
5. Slide cables into throttle cable bracket and engage retaining tabs. See Figure.
   Fig 3: Throttle Cable Attachment To Throttle Body

   Courtesy of DAIMLERCHRYSLER CORP.
6. Rotate the throttle cam forward to the wide open position and install speed control cable clasp. See Figure.
7. Rotate the throttle cam forward to the wide open position and install throttle cable clasp.
8. Install engine cover and throttle control shield, if equipped.
9. Install the negative battery cable.
10. Install the air cleaner lid and makeup air hose. Refer to appropriate article. Refer to (Refer to ENGINE/AIR INTAKE SYSTEM/AIR CLEANER ELEMENT - INSTALLATION) or (Refer to ENGINE/AIR INTAKE SYSTEM/AIR CLEANER ELEMENT - INSTALLATION) .