Rail Seals-Folding Top: Removal

Fig 1: Seals

Courtesy of DAIMLERCHRYSLER CORP.

1 - CONTOUR BOW 2 SEAL

2 - C-POST LINKAGE SEAL

Prior to removing the rail seals (1 and 2), determine the correct number of shims that will be required for installation.
Adhere tape to the side glass and mark the position of each rail seal in the fore/aft and up/down direction. This step is critical for positioning the new seals.
Using a 04.0 mm drill bit, remove the four rivets on each rear rail seal.
Remove the old seal and retainer assemblies.