Rear Seat Back Cover/Foam: Removal: Convertible
Courtesy of DAIMLERCHRYSLER CORP.
- Remove seat from vehicle. (Refer to BODY/SEATS/REAR SEAT - REMOVAL) .
- Remove rear seat back. (Refer to BODY/SEATS/REAR SEAT BACK - INSTALLATION) .
Courtesy of DAIMLERCHRYSLER CORP.
- Disengage the J-strap retainer.
Courtesy of DAIMLERCHRYSLER CORP.
- Roll flap back to access push pin fasteners (1).
Courtesy of DAIMLERCHRYSLER CORP.
| 1 - J-STRAP |
| 2 - HOOK AND LOOP |
| 3 - HOG RINGS |
- Raise back flap to release the hook and loop (2) to access the J-strap (1) and hog rings (3). Release J-strap (1) and cut the hog rings (3).
Courtesy of DAIMLERCHRYSLER CORP.
- Disconnect the lower J-strap from the rod.
Courtesy of DAIMLERCHRYSLER CORP.
- Disconnect the upper J-strap from the rod.
Courtesy of DAIMLERCHRYSLER CORP.
- Roll cover upward to hog rings (1). Cut hog rings to free cover.
Courtesy of DAIMLERCHRYSLER CORP.
- Roll seat cover bottom to clear the foam.
Courtesy of DAIMLERCHRYSLER CORP.
- Roll seat back cover to the hog rings. Cut hog rings (1).
Courtesy of DAIMLERCHRYSLER CORP.
- Pull back panel (1) free of the seat cover and foam (2).
Courtesy of DAIMLERCHRYSLER CORP.
- Remove seat back cover from the foam.