LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Lighting Systems - Exterior - Electrical Diagnostics >> Lamps/Lighting - Exterior - Electrical Diagnostics >> DTC Troubleshooting >> B1659-Front Fog Lamp Control Circuit Low >> Diagnostic Test

Diagnostic Test

  1. 1) INTERMITTENT CONDITION 

    Turn the ignition on.

    With the Scan Tool, clear all TIPM DTC's.

    Turn the Front Fog Lamps on.

    With the scan tool, read the DTC information.

    Does the Scan Tool read: B1659-FRONT FOG LAMP CONTROL CIRCUIT LOW? 

    Yes 

    1. Go to Step 2.

    No 

    1. The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
    2. Perform the BODY VERIFICATION TEST - VER 1 .
  2. 2)  (L89) (L90) FRONT FOG LAMP CONTROL CIRCUIT SHORT TO GROUND 

    Turn the ignition off.

    Disconnect the TIPM C11 harness connector.

    Disconnect the Front Fog Lamp harness connector.

    Measure the resistance between ground and the (L89) (L90) Front Fog Lamp Control circuit.

    Is the resistance below 5.0 ohms? 

    Yes 

    1. Repair the (L89) (L90) Front Fog Lamp Control circuit for a short to ground condition.
    2. Perform the BODY VERIFICATION TEST - VER 1 .

    No 

    1. Replace the Totally Integrated Power Module (TIPM) in accordance with the service information.
    2. Perform the BODY VERIFICATION TEST - VER 1 .
scientia non olet · About LEMON Manuals