Diagnostic Test

1) BODY CONTROL MODULE (BCM)

Fig 1: Connecting Scan Tool & Turning Ignition On
Courtesy of DAIMLERCHRYSLER CORP.

NOTE: This DTC indicates an internal BCM fault.

With the DRBIII®, read and record the BCM DTCs and then erase the BCM DTCs

Perform 3 ignition key cycles, leaving the ignition key on for a minimum of 30 seconds per cycle.

With the DRBIII® , read the BCM DTCs.

Did this DTC set again?

Yes
1. Replace the Body Control Module. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES/BODY CONTROL/CENTRAL TIMER MODUL - REMOVAL) .
2. Perform BODY VERIFICATION TEST .
No
1. The condition that caused this DTC to set is currently not present.
2. Perform BODY VERIFICATION TEST .