LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> 300 Base, 42RLE/VLP >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting Systems - Exterior (Service Information) >> Switch-Headlamp >> Removal

Lighting Systems - Exterior (Service Information): Switch-Headlamp: Removal

  1. Disconnect and isolate the battery negative cable.
    WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service. Failure to do so may result in accidental airbag deployment, personal injury or death.
    Fig 1: Headlamp Switch Electrical Connector
    GC0016116Courtesy of DAIMLERCHRYSLER CORP.
  2. Remove steering column opening cover (Refer to BODY/INSTRUMENT PANEL/STEERING COLUMN OPENING COVER - REMOVAL) .
  3. From underneath and behind the instrument panel, push up on the lower clip on headlamp switch then wiggle it down and out of instrument panel.
  4. Disconnect the headlamp switch electrical connector.
scientia non olet · About LEMON Manuals