Stationary Glass: Windshield: Removal

Fig 1: Adhesive Separation

Courtesy of DAIMLERCHRYSLER CORP.

Before proceeding with the following repair procedure, review all warnings and cautions (Refer to BODY/STATIONARY GLASS - WARNING) .
Remove the rear view mirror (Refer to BODY/INTERIOR/REAR VIEW MIRROR - REMOVAL) .
Remove the cowl grille (Refer to BODY/EXTERIOR/COWL GRILLE - REMOVAL.)
CAUTION: Be careful not to damage painted surfaces when removing moldings or cutting urethane around the windshield.
Remove the windshield side moldings.
Using an assistant and a wire-type windshield cut-out tool (1, 3 and 4), cut and separate the urethane adhesive (2) securing the windshield to the windshield fence.
Carefully remove the windshield from the vehicle.