LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> Sebring Limited, 2D Convertible >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Interior & Exterior - Except Coupe >> Seats >> Front Seat Cushion Cover >> Removal - Front Seat Cushion Cover

Removal - Front Seat Cushion Cover

NOTE: Fabric covered cushions are serviced as an assembly.
  1. Remove seat from vehicle.
  2. Remove front seat cushion side shields and disconnect wire connectors, if equipped.
  3. Remove seat back.
  4. Remove seat cushion bolts.
  5. Disconnect wire harness fasteners from cushion pan. See Figure.
  6. Disengage J-strap attaching seat cover from the seat cushion frame. See Fig 1.
  7. Pull cover off to the hog rings. See Fig 2.
  8. Cut hog rings attaching seat cover seat cushion.
  9. Remove seat cushion cover from seat cushion.
Fig 1: Front Seat Cushion J-Strap
GC0031510Courtesy of DAIMLERCHRYSLER CORP.
1 - J-STRAP
Fig 2: Seat Cushion Cover
GC0031511Courtesy of DAIMLERCHRYSLER CORP.
1 - SEAT COVER
2 - HOG RINGS
scientia non olet · About LEMON Manuals