Top Of Glass - Inboard/Outboard Adjustments

Remove quarter trim panel. (Refer to BODY/INTERIOR/QUARTER PANEL TRIM - REMOVAL)
NOTE: Alternatively, the lower adjustment can be accessed through a hole at the bottom of the quarter trim panel. This hole can be located by removing the rear seat cushion. (Refer to BODY/SEATS/SEAT CUSHION - REMOVAL)
Remove center and rear side rail weatherstrips from side rail weatherstrip retainer channels.
Using a suitable wrench, loosen the lower jack screw jam nuts.
Raise quarter glass.
Using a suitable Allen wrench, rotate jackscrews to achieve the proper gap between the door glass weatherstrip retainer channel. See Figure.
Verify that the quarter glass maintains even contact with the outer belt weatherstrip.
Install center and rear side rail weatherstrips to side rail weatherstrip retainer channels.
Cycle quarter glass between full up and full down positions. Verify operation and adjust as necessary.
Tighten all fasteners.
Verify that the top edge of the door glass is beneath the lip of the weatherstrip with glass in the full up position.
Install quarter trim panel. (Refer to BODY/INTERIOR/QUARTER PANEL TRIM - INSTALLATION)