Bottom Of Glass - Inboard/Outboard Adjustments

1. Remove the speaker cover, speaker and speaker cup, if equipped.
2. Using a suitable offset wrench, loosen the upper forward jack screw set nut. See Fig 1.
3. Using a suitable Allen wrench, rotate the jack-screw to achieve the proper gap between the door glass and the quarter glass seal. See Fig 2 and Figure. Tighten all fasteners prior to measuring the gaps.
4. Install speaker cup, if equipped, speaker and cover.

Fig 1: Forward Jack Screw Adjustment

Courtesy of DAIMLERCHRYSLER CORP.

1 - JACK SCREW ADJUSTMENT

2 - QUARTER TRIM PANEL

3 - SPEAKER OPENING

Fig 2: In/Out Allen Adjustment

Courtesy of DAIMLERCHRYSLER CORP.

1 - SPEAKER OPENING

2 - TRIM PANEL HOLE

3 - QUARTER TRIM PANEL

4 - ALLEN WRENCH