LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> Sebring Limited, 2D Convertible >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures - Except Coupe >> Diagnostic Information And Procedures >> Instrument Cluster >> Symptom: PANEL DIMMING OUTPUT SHORT >> Diagnostic Procedure

Diagnostic Procedure

DIAGNOSTIC PROCEDURE - PCM MESSAGE NOT RECEIVED

TEST ACTION APPLICABILITY
1 Turn the ignition on.
With the DRBIII®, record and erase Body Control Module DTC's.
Turn the ignition off, wait 15 seconds, then turn the ignition on.
Turn on the Headlamps.
With the DRBIII®, read DTCs.
Does the DRBIII® display PANEL DIMMING OUTPUT SHORT?
Yes --> Go To 2
No --> Test Complete.		 All
2 Turn the ignition on.
With the DRBIII®, erase Body Control Module DTCs.
Turn the ignition off.
Using the Wiring Diagrams as a guide, disconnect each dimmed component, one at a time while checking for the DTC to reset.
Turn the ignition on.
Turn the Headlamps on.
With the DRBIII®, read DTCs.
Does the DRBIII® display PANEL DIMMING OUTPUT SHORT?
Yes --> Go To 3
No --> Replace the shorted component as necessary. Perform BODY VERIFICATION TEST - VER 1 .		 All
3 Turn the ignition off.
Using the Wiring Diagrams as a guide, disconnect each dimmed component and test the dimming circuit for a short to ground condition.
Were there any problems found?
Yes --> Repair the Panel Lamps Driver circuit for a short to ground. Perform BODY VERIFICATION TEST - VER 1 .
No --> Replace and program the Body Control Module in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1 .		 All
scientia non olet · About LEMON Manuals