LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> Sebring Limited, 2D Convertible >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures - Except Coupe >> Diagnostic Information And Procedures >> Heating & A/C >> Symptom: SUN LOAD SENSOR FAILURE - ATC >> Diagnostic Procedure

Diagnostic Procedure

DIAGNOSTIC PROCEDURE - SUN LOAD SENSOR FAILURE - ATC

TEST ACTION APPLICABILITY
1
NOTE: It is advisable to perform the ATC System Test before attempting to diagnose this trouble code.
Turn the ignition off.Disconnect the Sun Sensor/VTSS LED harness connector.Turn the ignition on.With the DRBIII® in Sensor Display, read the Sun Sensor voltage.Is the voltage below 0.2 volts?Yes --> Go To 2No --> Replace the Sun Sensor in accordance with the Service Information.Perform BODY VERIFICATION TEST - VER 1 .		 All
2 Turn the ignition off.
Disconnect the Sun Sensor/VTSS LED harness connector.
Disconnect the Body Control Module C1 & C2 harness connectors.
Measure the resistance between ground and the Sun Sensor Signal circuit.
Is the resistance below 100.0 ohms?
Yes --> Repair the Sun Sensor Signal circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Go To 3		 All
3 Turn the ignition off.
Disconnect the Sun Sensor/VTSS LED harness connector.
Disconnect the Body Control Module C1 & C2 harness connectors.
Measure the resistance between the Sun Sensor Signal circuit and the Sensor Ground circuit in the Sun Sensor harness connector.
Is the resistance below 100.0 ohms?
Yes --> Repair the Sun Sensor Signal circuit for a short to the Sensor Ground circuit.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Go To 4		 All
4 If there are no possible causes remaining, view repair.
Repair
Replace and program the Body Control Module in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1 .		 All
scientia non olet · About LEMON Manuals