LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> Pacifica Limited >> Repair and Diagnosis >> Electrical >> Gauges >> Body Diagnostic Procedures - Diagnostic Information And Procedures - Park Assist System, Power Door Locks/RKE, Power Door - Liftgate, Power Mirror, Power Seats >> Power Seats >> Symptom: DRIVER RECLINE SWITCH STUCK - DDM >> Diagnostic Procedure

Diagnostic Procedure

DRIVER RECLINE SWITCH STUCK - DDM SYMPTOM CHART

TEST ACTION APPLICABILITY
1 Check the seat switches mechanical operation and also check for a possible obstruction. Correct if necessary.
Turn the ignition on.
With the DRBIII®, erase DTCs.
Cycle the ignition switch from Off to Run.
Operate the Seat Switch in all positions several times.
With the DRBIII®, read DTCs.
Does the DRBIII® display DRIVER RECLINE SWITCH STUCK?
Yes --> Go To 2
No --> The condition that caused this code to set is not present at this time. Operate the switch several times to ensure it does not stick. If the switch ever sticks, replace it.
Perform POWER SEAT SYSTEM VERIFICATION TEST - VER 1 .		 All
2 Disconnect the Driver Power Seat Switch connector.
Turn the ignition on.
With the DRBIII®, erase DTCs.
Cycle the ignition switch from Off to Run and wait 30 seconds.
With the DRBIII®, read DTCs.
Does the DRBIII® display DRIVER RECLINE SWITCH STUCK?
Yes --> Go To 3
No --> Replace the Driver Power Seat Switch.
Perform POWER SEAT SYSTEM VERIFICATION TEST - VER 1 .		 All
3 Turn the ignition off.
Disconnect the Driver Power Seat Switch connector.
Disconnect the Driver Door Module C2 connector.
Inspect the Driver Seat Recliner/Lumbar Out Switch MUX circuit for a partial short to ground or to another circuit in the seat switch harness.
Were there any problems found?
No --> Replace the Driver Door Module.
Perform BODY VERIFICATION TEST - VER 1 .
Yes --> Repair the Driver Seat Recliner/Lumbar Out Switch MUX circuit as necessary.
Perform POWER SEAT SYSTEM VERIFICATION TEST - VER 1 .		 All
scientia non olet · About LEMON Manuals