LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> Pacifica Limited >> Repair and Diagnosis >> Electrical >> Gauges >> Body - Interior & Exterior >> Instrument Panel >> Cluster Bezel >> Installation

Cluster Bezel: Installation

  1. Connect the electrical connector to the instrument panel switch pod (EVIC, NAV, Clock, and Hazard Switch).
  2. Position the cluster bezel over retaining slots and firmly snap into place. See Figure.
  3. Install the eight retaining screws to the cluster bezel. See Figure.
  4. Position the left side instrument panel center stack trim from panel over retaining slots and firmly snap into place.
  5. Install the instrument panel center bezel (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL CENTER BEZEL - INSTALLATION) .
  6. Position the left lower instrument panel trim plate over the retaining slots and firmly snap into place. Install the two screws.
  7. Position the left end cover over the retaining slots and firmly snap into place.
  8. Install the knee blocker airbag (Refer to ELECTRICAL/RESTRAINTS/KNEE BLOCKER AIRBAG - INSTALLATION) .
  9. Position the steering opening cover over retaining and firmly snap into place. Install the two retaining screws.
    WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. (Refer to ELECTRICAL/RESTRAINTS - DIAGNOSIS AND TESTING - AIRBAG SYSTEM) FIRST.
  10. Verify vehicle and system operation.
scientia non olet · About LEMON Manuals