Diagnostic Procedure
EBL RELAY CONTROL CIRCUIT OPEN SYMPTOM CHART
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Turn the ignition on. With the DRBIII®, erase DTCs. Turn the ignition off, wait 30 seconds, then turn the ignition on. With the DRBIII®, read DTCs. Does the DRBIII® display: EBL RELAY CONTROL CIRCUIT OPEN? Yes --> Go To 2 No --> The condition that caused the symptom is not currently present. Refer to any Technical Service Bulletins (TSBs) that may apply. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors. Perform BODY VERIFICATION TEST - VER 1 . |
All |
| 2 | Turn the ignition off. Check fuse #5 in the IPM. Is the fuse open? Yes --> Replace the fuse. Check for a short to ground in the Rear Window Defogger Relay Output circuit from the IPM to the defogger grid. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 3 |
All |
| 3 | Turn the ignition off. Install a substitute relay in place of the Rear Window Defogger Relay (EBL). With the DRBIII®, erase DTCs. Turn the ignition on. With the DRBIII®, read DTCs. Does the DRBIII® display: EBL RELAY CONTROL CIRCUIT OPEN? Yes --> Replace the IPM in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . No --> Replace the Rear Window Defogger Relay (EBL). Perform BODY VERIFICATION TEST - VER 1 . |
All |