Diagnostic Procedure
DRIVER HEATED SEAT SWITCH SHORT - DDM SYMPTOM CHART
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Turn the ignition on. With the DRBIII®, erase DTCs. Cycle the ignition switch from Off to Run. Operate the suspect switch in both positions several times. With the DRBIII®, read DTCs. Does the DRBIII® display DRIVER HEATED SEAT SWITCH SHORT? Yes --> Go To 2 No --> The condition that caused this code to set is not present at this time. Perform BODY VERIFICATION TEST - VER 1 . |
All |
| 2 | Disconnect the Driver Power Seat Switch connector. Turn the ignition on. With the DRBIII®, erase DTCs. Cycle the ignition switch from Off to Run and wait 10 seconds. With the DRBIII®, read DTCs. Does the DRBIII® display DRIVER HEATED SEAT SWITCH SHORT? Yes --> Go To 3 No --> Replace the Power Seat Switch. Perform BODY VERIFICATION TEST - VER 1 . |
All |
| 3 | Turn the ignition off. Disconnect the Driver Power Seat Switch connector. Disconnect the Driver Door Module C2 connector. Inspect the Driver Heated Seat Switch MUX circuit for a short to ground or to another circuit in the seat switch harness. Were there any problems found? Yes --> Repair the Driver Heated Seat Switch MUX circuit for a short to ground. Perform BODY VERIFICATION TEST - VER 1 . No --> Replace the Driver Door Module. Perform BODY VERIFICATION TEST - VER 1 . |
All |