Diagnostic Procedure
PDM MESSAGES NOT RECEIVED SYMPTOM CHART
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Turn the ignition on. With the DRBIII®, attempt to communicate with the Passenger Door Module. Was the DRBIII® able to I/D or communicate with the PDM? Yes --> Go To 2 No --> Refer to the COMMUNICATION category for the related symptom(s). Perform BODY VERIFICATION TEST - VER 1 . |
All |
| 2 | With the DRBIII®, erase DTC's. Cycle the ignition switch from off to on, operate the door locks from the passenger's door and wait approximately 1 minute. With the DRBIII®, read DTC's. Did this DTC reset? Yes --> Replace the module which set the DTC in accordance with the service information. Perform BODY VERIFICATION TEST - VER 1 . No --> Test Complete. |
All |