LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> Pacifica Limited >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Body Diagnostic Procedures - Diagnostic Information And Procedures - Adjustable Pedals, Airbag >> Diagnostic Information And Procedures >> Airbag >> Symptom: PCM MESSAGES NOT RECEIVED - AMPLIFIER >> Diagnostic Procedure

Diagnostic Procedure

PCM MESSAGES NOT RECEIVED - AMPLIFIER SYMPTOM CHART

TEST ACTION APPLICABILITY
1 Turn the ignition on.
With the DRBIII®, enter Instrument Cluster, System Tests then PCM Monitor.
Does the DRBIII® display: PCM active on the BUS?
Yes --> Erase the DTC, if DTC resets, replace the Amplifier in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Go To 2		 All
2 Turn the ignition on.
With the DRBIII®, attempt to communicate with the PCM.
Was the DRBIII® able to communicate with the PCM?
Yes --> Go To 3
No --> Refer to the COMMUNICATION category and perform the appropriate symptom .
Perform BODY VERIFICATION TEST - VER 1 .		 All
3 Turn the ignition off.
Disconnect the PCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMINALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.

Measure the resistance of the PCI Bus circuit between the DLC and the PCM connector.
Is the resistance below 5.0 ohms?
Yes --> Replace and program the Powertrain Control Module in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Repair the PCI Bus circuit for an open.
Perform BODY VERIFICATION TEST - VER 1 .		 All
scientia non olet · About LEMON Manuals