LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> Pacifica Limited >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Body Diagnostic Procedures - Diagnostic Information And Procedures - Adjustable Pedals, Airbag >> Diagnostic Information And Procedures >> Airbag >> Symptom: ALL OUTPUTS SHORT >> Diagnostic Procedure

Diagnostic Procedure

ALL OUTPUTS SHORT SYMPTOM CHART

TEST ACTION APPLICABILITY
1 Turn the ignition on.
Turn the Radio on.
With the DRBIII®, erase the audio DTC's.
Cycle the ignition switch from off to on and wait 10 seconds.
With the DRBIII®, read the audio DTC's.
Does the DRBIII® display ALL OUTPUTS SHORT?
Yes --> Go To 2
No --> Refer to SYSTEM WIRING DIAGRAMS located in the service information to help isolate a possible short.
Perform BODY VERIFICATION TEST - VER 1 .
All
2 Turn the ignition off.
Disconnect the Amplifier C2 harness connector.
Turn the ignition on.
Turn the radio on.
With the DRBIII®, erase the audio DTCs.
Cycle the ignition switch from off to on and wait 10 seconds.
With the DRBIII®, read DTC's.
Does the DRBIII® display ALL OUTPUTS SHORT?
Yes --> Go To 3
No --> Replace the Amplifier in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1 .
All
3 Turn the ignition off.
Disconnect the Amplifier C2 harness connector.
Disconnect the Radio (C1 on premium) harness connector.
Measure the resistance between ground and each radio right and left (+) circuit.
Is the resistance below 1000.0 (1K) ohms?
Yes --> Repair the radio right or left (+) circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Go To 4
All
4 Turn the ignition off.
Disconnect the Amplifier C2 harness connector.
Disconnect the Radio (C1 on premium) harness connector.
Measure the resistance between ground and each radio right and left (-) circuit.
Is the resistance below 1000.0 (1K) ohms?
Yes --> Repair the radio right or left (-) circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Go To 5
All
5 Turn the ignition off.
Disconnect the Amplifier C2 harness connector.
Disconnect the Radio (C1 on premium) harness connector.
Measure the resistance between each radio (+) circuit and each radio (-) circuit.
Is the resistance below 1000.0 (1K) ohms for any of the measurements?
Yes --> Repair the radio circuits shorted together.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Go To 6
All
6 If there are no possible causes remaining, view repair.
Repair
Replace the Radio.
Perform BODY VERIFICATION TEST - VER 1 .
All